15kV UNISHIELD 133% – EPR – CPE

Specification:
HW210
Power Cable – Unishield
15KV UL Type MV-105, 105°C
Single Conductor, Shielded
EPR Insulation, CPE Jacket
133% Insulation Level
Copper Conductor
 

Catalog Number	Size AWG/ kcmil	No. of Strands	Insul. Thickness Mils	Jacket Thickness Mils	Insul. Diameter Inch	Drain Wire Size AWG	Cond. Diameter Inch	Overall Diameter Inch	Net Weight Lbs/Mft
HW210 00201	2	7	220	80	0.76	19	0.27	0.94	574
HW210 10101	1/0	19	220	80	0.83	18	0.34	1.02	753
HW210 20101	2/0	19	220	80	0.87	18	0.38	1.07	867
HW210 40101	4/0	19	220	80	0.97	18	0.48	1.17	1171
HW210 25001	250	37	220	85	1.03	17	0.53	1.24	1349
HW210 35001	350	37	220	85	1.12	17	0.62	1.33	1720
HW210 50001	500	37	220	85	1.25	17	0.72	1.46	2267
HW210 75001	750	61	220	100	1.43	16	0.91	1.67	3216
HW210 10001	1000	61	220	115	1.59	15	1.06	1.86	4164

Application:
For use in power circuits up to 15KV when installed in open air, conduit, duct, cable tray when CT rated, or direct buried in earth, in wet and dry locations. Used for critical applications in harsh and caustic environments in chemical plants, refineries, steel mills, industrial plants, commercial buildings, utility substations and generating stations. UL approved for use at 105°C for continuous operation, 140°C for emergency overload conditions, and 250°C for short circuit conditions.

Conductor:
Compact soft bare annealed copper per ASTM B-3, Class B stranding per ASTM B-496, with a semi-conducting conductor shield.

Insulation:
Ethylene propylene rubber (EPR) per ICEA S-97-682.

Shield:
Six (6) corrugated copper shield wires longitudinally embedded in an exterior semi-conducting CPE jacket per ICEA S-97-682.

Jacket:
Sunlight-resistant CPE per ICEA S-97-682 and UL Standard 1072.

Flame Tests:
•IEEE 383 70,000 BTU/hr flame test – CT-listed sizes 1/0AWG and larger
•IEEE1202 70,000 BTU/hr, CSA FT4 flame test
•ICEA T-29-520 210,000 BTU/hr flame test

Additional Standards:
•ICEA S-93-639
•NEMA WC74
•AEIC CS8

Note:
CT rated on sizes 1/0 AWG and larger.